ron17t
Feature Winner
Posts: 1,180
|
Post by ron17t on Aug 21, 2013 20:18:01 GMT -5
You need pipes off the manifolds-they don't seem to run good without them.You don't need the o2 sensors,but I use them on my cars.If the battery has been disconnected or dead they sometimes need to run for a while to relearn idle.
|
|
|
Post by green29 on Aug 25, 2013 2:21:53 GMT -5
Its my first Ford and I've got a 94 mercury when I got it it was striped. The mass air flow sensor was gone it run good for a while but now you Haveing have TPS disconnected to idol. Is that because the mass air flow is gone.
|
|
|
Post by jugulator on Aug 25, 2013 10:24:26 GMT -5
get a maf for it,,
|
|
ron17t
Feature Winner
Posts: 1,180
|
Post by ron17t on Sept 1, 2013 13:15:36 GMT -5
This car had a stock 4.6.Ran the entire feature with the pedal on the floor in wet clay,stalled 2 times but restarted in limp mode.Engine had 316,000 miles. Front spindle broke at the end of the feature,so stock front ends are the weak point on these cars.
|
|
|
Post by fordpower111 on Sept 1, 2013 14:48:22 GMT -5
I think I would invest some time and money in a trailer.
|
|
|
Post by jugulator on Sept 2, 2013 10:55:36 GMT -5
yeah,,some tralier and i would have chained it down better too..
good car,,,
|
|
derbydogs
Future Icon
chick got me good
Posts: 59
|
Post by derbydogs on Sept 5, 2013 16:50:21 GMT -5
my lincoln folded in the rear really bad should I pull it out or let it go
|
|
derbydogs
Future Icon
chick got me good
Posts: 59
|
Post by derbydogs on Sept 5, 2013 16:57:16 GMT -5
95 town car Attachments:
|
|
ron17t
Feature Winner
Posts: 1,180
|
Post by ron17t on Sept 5, 2013 19:33:40 GMT -5
I'd run it the way it is, it packed in perfect.I have a vic like that and it's going to run as is.Just check the humps and make sure they 're not blowi ng out, if they are beat them in and plate if you can
|
|
|
Post by fordpower111 on Sept 5, 2013 21:10:14 GMT -5
I would trim or hammer in a little around the wheel well. Don't want that getting into your tire.
|
|
derbydogs
Future Icon
chick got me good
Posts: 59
|
Post by derbydogs on Sept 6, 2013 10:14:30 GMT -5
Not alowed hump plates entire frame must be atock
|
|
|
Post by jugulator on Sept 16, 2013 17:12:53 GMT -5
Ok,, all you 4.6 motor heads...
free tip... use a fram PH 10060 oil filter... Its smaller than the stock filter .
the stock size filter gets hit with the pitman arm when the car bends,, ..
...............lenny
|
|
|
Post by jugulator on Sept 26, 2013 12:49:17 GMT -5
|
|
ron17t
Feature Winner
Posts: 1,180
|
Post by ron17t on Sept 26, 2013 17:14:36 GMT -5
Does that belt touch the waterpump ? If not , and your just running a loop system, how long are your heats and features? I've thought of not running a radiator in one of these but have been afraid to try.
|
|
|
Post by jugulator on Sept 29, 2013 11:14:27 GMT -5
Does that belt touch the waterpump ? If not , and your just running a loop system, how long are your heats and features? I've thought of not running a radiator in one of these but have been afraid to try. oh,, you noticed THAT,,, thats a 5.0 belt,,,, the water pump doesn't turn,, why curculate the water if its not being cooled.. how long the heats,, ?? about 15 minutes,, ........lenny
|
|