|
Post by hellbent09 on Sept 29, 2013 7:07:45 GMT -5
you need a tougher bumper. can you run straps off your top core support to your bumper?
|
|
|
Post by lilbutchusmc on Sept 29, 2013 18:07:34 GMT -5
you need a tougher bumper. can you run straps off your top core support to your bumper? Nope. You can wire from hood/top of core support but no welding. I was literally the last car through inspection and didn't have time to wire hardly anything.
|
|
|
Post by ramsey18 on Dec 4, 2013 8:26:35 GMT -5
What do you guys think about the 232 inline 6?
|
|
|
Post by C4 on Dec 4, 2013 11:52:59 GMT -5
I haven't used one. Have seen mixed results with others using them.
|
|
|
Post by ramsey18 on Dec 4, 2013 12:13:39 GMT -5
I think I'm going to give it a try. It has low miles and runs great..
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Dec 4, 2013 23:07:31 GMT -5
i put one in a s-10 blazer for next year.we will see how it does.the straight six (242)i had in my jeep had great torque even when it was hot and running like shit.
|
|
|
Post by jpalmer34 on Dec 15, 2013 15:18:47 GMT -5
How good are the 73 Amc hornet "wagons"?
|
|
|
Post by trasher on May 26, 2014 21:57:51 GMT -5
What about a 79 gremlin I see a lot about pre 79!!!
|
|
|
Post by trasher on May 26, 2014 22:02:27 GMT -5
What about a 79 gremlin I see a lot about pre 79!!! My bad a 79 spirit?
|
|
|
Post by C4 on May 26, 2014 22:33:34 GMT -5
|
|
|
Post by lilbutchusmc on Jun 7, 2014 20:57:14 GMT -5
Will a hornet fenders/hood bolt up with a gremlin?
|
|
|
Post by C4 on Jun 8, 2014 1:10:18 GMT -5
Will a hornet fenders/hood bolt up with a gremlin? Should....hood bolts right on. As far as I know the cars are virtually the same from the front floor pans forward.
|
|
|
Post by lilbutchusmc on Jun 8, 2014 12:48:22 GMT -5
What about 77/78 gremlins. I know the fronts are a little different.
|
|
|
Post by C4 on Jun 8, 2014 12:52:35 GMT -5
77 was the last year for Hornet and it did not get the shorter nose like the Gremlin did.
If you are lacking a fender, and can get away with making your own bolt holes, grab a tape measure, Head to any bone yard & grab something half ass close to the same size.
Iron yard probably let you take one cheaper than a parts yard.
|
|
|
Post by lilbutchusmc on Jun 8, 2014 13:51:41 GMT -5
I found a 74 hornet guy is scrapping. Pulling as much off as I can
|
|