|
Post by DerbyKing88s on May 13, 2019 22:37:52 GMT -5
Ya back end rolled and packed
|
|
owen11x
Feature Winner
Ford makes it, Chevy shakes it, Mopar breaks it!
Posts: 2,585
|
Post by owen11x on May 13, 2019 22:53:29 GMT -5
Looked like both trunks went to the dirt in the video? Thought you lived by the cut quarters off to frame and wrap it all
|
|
|
Post by DerbyKing88s on May 13, 2019 23:22:36 GMT -5
Not with hump plates, and the 75 went up and in, humps wrapped in and bumper pushed straight in after it went up so I looks like it was low but it’s all good. The 71 didn’t make it to the dirt but did start to go down on driver side after the one guy went up on it, what u see down low is just sheet metal, gave right after hump plate which is typical
|
|
|
Post by cheezwhiz31 on May 14, 2019 8:00:12 GMT -5
Any pics of the trunks/rear rails???
|
|
|
Post by negative696 on May 29, 2019 21:02:01 GMT -5
Any pics of the other front? That thing looked like it bent all kinds of stupid.....but I was drunk so who knows how it actually was.
|
|
|
Post by DerbyKing88s on May 29, 2019 21:05:33 GMT -5
Any pics of the other front? That thing looked like it bent all kinds of stupid.....but I was drunk so who knows how it actually was. of which car, the 71 went down but the 75 was just fine
|
|
|
Post by beefybuilt104 on May 30, 2019 9:35:10 GMT -5
Any pics of the other front? That thing looked like it bent all kinds of stupid.....but I was drunk so who knows how it actually was. of which car, the 71 went down but the 75 was just fine I thought the 75 did an accordion in front of the a arm on the passenger side?
|
|
|
Post by DerbyKing88s on May 30, 2019 11:21:35 GMT -5
Started to push at the S up front but nothing bad
|
|
|
Post by dean88 on Sept 1, 2019 20:55:56 GMT -5
|
|
|
Post by DerbyKing88s on Sept 25, 2019 21:00:20 GMT -5
|
|
Landshark007
Feature Winner
I'm not here to win I'm here to make sure you don't win
Posts: 4,228
|
Post by Landshark007 on Sept 25, 2019 21:25:49 GMT -5
Got 2nd and Maddog, trunk was super rusty and I believe the seam wasnt welded from the factory between the body frame rails and the rear frame section. Where did you run this at
|
|
|
Post by dean88 on Sept 25, 2019 21:48:23 GMT -5
Belton Tx
|
|
Landshark007
Feature Winner
I'm not here to win I'm here to make sure you don't win
Posts: 4,228
|
Post by Landshark007 on Sept 25, 2019 22:17:02 GMT -5
|
|
|
Post by DerbyKing88s on Oct 16, 2019 10:53:03 GMT -5
|
|
|
Post by smashincwa on Nov 9, 2019 21:34:16 GMT -5
Thank you, I believe there is a slight difference in the lower a arms from the 69-72’s to the 73-6’s. I think it will be alright but we’ll find out. I also don’t think they will go over, would take a lot to get these 8-9k pound caddies over but you never know. Just a couple days away from finding out a side hit will push the tire under, exposing the rim and your over. With the positive camber, you are pretty much "tripping" the side of the car since the width (or stance) of the car is shortened. What's easier to push over, someone standing with the legs together or apart? Watch the blizzard bash video rollovers. 4:00 minute mark confirms the flat tire issue from too much positive camber: www.youtube.com/watch?v=6zXOjk0lzw8
|
|