|
Post by cheezwhiz31 on Jul 6, 2021 13:27:49 GMT -5
I am going to strip my 76 impala. It has a nice heavy 4 point cage and tank holder off back bar and a roll bar. Dash it cut out trans tunnel is pretty straight still. Back end of car it bent up to back window. Rear bumper fell off but i will let it go with 70's Buick has a bend in the bottom of it but i think would go again. 8 inch of welds on doors...front end is nosed up 10 inchs or so i'd say have 1 4x4 plate on each S curve straight from them forward. Factory uppers welded down tie rods in good shape has a 76 Chevy bumper ends curled center vent hole bent up a little so weld a pipe in them and i think will hold good now. Not stuffed chrome welded down. 5/8 rod. Could get another run out of it. Using nose and i think the back would take some more especially if a guy put a tight GTP in it. I am going to take my engine and trans out of it and all the stuff in side but would leave the rest. Or i'm going to strip it down keep all the stuff off it and scrap it. Doesn't really matter to me. 800$ takes the car, Bumpers,Cage,Suspension stuff...
WILL BE STRIPPED BY WEEKEND AND SCRAPPED BY THE FOLLOWING...7-17-21
|
|