|
Post by frisbee4269 on Jun 27, 2016 18:11:26 GMT -5
Running a 97 gran marquis... Was told to remove the dash... My question is do I have to? And now that I did it, it just flops around... Can I mount it to the front spreader bar??? And can I weld up a rod straight through the floor board to the transmission linkage??
|
|
demoboy333
Feature Winner
Enter your message here...
Posts: 3,124
|
Post by demoboy333 on Jul 7, 2016 15:07:36 GMT -5
I welded off my dash bar to hold my column in place. An yes u can use a straight rod. As known as a push pull shifter it's the old skool shifter. Just a heads up tape the end of ur rod that sits in ur hand or will end up with it stuck in ur leg or arm
|
|
|
Post by jugulator on Jul 12, 2016 11:19:41 GMT -5
are you using the stock column with the key ign switch ?
than you need the left section of the dash to hold everything,,
the 97 column cable shifter works ok, for a stock show,,
if not,, an 80s column will fit,,
|
|