|
Post by derby2racer on Apr 6, 2016 23:33:02 GMT -5
Wondering if anyone runs rubber brake lines? Assuming it would be easier to run than trying to bend metal brake lines for each car if you use a pinion brake.
|
|
2727
Heat Winner
Posts: 541
|
Post by 2727 on Apr 7, 2016 3:20:44 GMT -5
I'm not sure about others but I use steel braided brake line I order off of eBay. It may not be a good to use but I haven't had problems with it. I personally like it and it's easy to use.
|
|
|
Post by stellis124 on Apr 7, 2016 8:56:15 GMT -5
I only use rubber brake lines if I acquire a car that has a hole in the lines and I need to patch them ill just patch it rubber hose. I havnt had a problem yet
|
|
|
Post by gmwagon on Apr 7, 2016 10:48:30 GMT -5
New brake line from master threw firewall along drivers door bar back to rubber line from rear end remove after and reuse
|
|
|
Post by gmwagon on Apr 7, 2016 10:48:56 GMT -5
New brake line from master threw firewall along drivers door bar back to rubber line from rear end remove after and reuse
|
|
|
Post by STROMI 121 on Apr 7, 2016 12:10:16 GMT -5
New brake line from master threw firewall along drivers door bar back to rubber line from rear end remove after and reuse That's how I roll.
|
|
|
Post by klicky96 on Apr 7, 2016 12:38:01 GMT -5
I only use rubber brake lines if I acquire a car that has a hole in the lines and I need to patch them ill just patch it rubber hose. I havnt had a problem yet So you're using regular hose? I sure hope not
|
|
|
Post by redneckracing12 on Apr 7, 2016 16:30:00 GMT -5
New brake line from master threw firewall along drivers door bar back to rubber line from rear end remove after and reuse That's how I roll. Same here, only I just go from floor mounted pedal back.
|
|
|
Post by STROMI 121 on Apr 7, 2016 17:24:30 GMT -5
Same here, only I just go from floor mounted pedal back. That too. Depends on what I am building.
|
|
|
Post by derby2racer on Apr 7, 2016 21:14:34 GMT -5
Ok, so as you can see, i havent done anything with brake lines. So next question would be, how do you connect hydrolic hose or braided line to the steel fitting to screw it into your master cylinder or pinion brake setup?
|
|
2727
Heat Winner
Posts: 541
|
Post by 2727 on Apr 8, 2016 2:51:05 GMT -5
I got a 3/16" fitting from Napa to connect them.
|
|
|
Post by stellis124 on Apr 8, 2016 6:19:02 GMT -5
I only use rubber brake lines if I acquire a car that has a hole in the lines and I need to patch them ill just patch it rubber hose. I havnt had a problem yet So you're using regular hose? I sure hope not regular hose, no. high pressure yes.
|
|