|
|
Post by cowdoc on Mar 9, 2015 21:54:07 GMT -5
Nylon flex fans from DayMotor sports and homemade rubber shrouds here too
|
|
|
|
Post by cheezwhiz31 on Mar 10, 2015 6:52:36 GMT -5
some steel mesh bolted infront. Then run smaller threaded rod in 4 spots front and back of radiator. Butt the outer ones to the tanks so radiator doesn't slide all over side to side and bolt it down tight. Plastic 16 in i think fan from jegs. have had good luck with this set up. Oh and a can of foam...   |
|
|
|
Post by Impin Aint Easy on Mar 27, 2015 9:36:26 GMT -5
How do you like the flex fans i though they only work at higher rpm I thought the flex fans would flatten out at higher rpms and not work as well as metal/hard plastic. My understanding of these fans is that they dont work properly until they flex at a higher rpm.. So during a caution at idle they will not pull air.. What do you figure Stromboni? |
|
|
|
Post by STROMI 121 on Mar 27, 2015 11:37:10 GMT -5
I don't know but they have always worked well for me. And they don't tear anything up if they contact something.
|
|
|
|
Post by STROMI 121 on Mar 27, 2015 11:38:05 GMT -5
There are many different options on fans.
|
|
