snake
Heat Winner
Posts: 368
|
Post by snake on Jun 7, 2015 10:35:17 GMT -5
Made from the yoke of the original, 1/2" plate machine out to fit tightly. I cut off the ears, machined the yoke to round, and made a small step for an area to weld the plate to. Drilled and tapped plate to 7/16. Will eventually be used for a pinion brake set up. I cannot find anybody that makes one would you be willing to make or sell one ? thanks
|
|
snake
Heat Winner
Posts: 368
|
Post by snake on May 25, 2015 8:34:21 GMT -5
Need price on sterling 10.25 pinion brake setup 60567 Thanks
|
|
snake
Heat Winner
Posts: 368
|
Post by snake on May 12, 2015 23:29:35 GMT -5
|
|
snake
Heat Winner
Posts: 368
|
Post by snake on Apr 12, 2015 12:33:47 GMT -5
anybody got a Sterling 10.25 Pinion flanged Yoke
|
|
snake
Heat Winner
Posts: 368
|
Post by snake on Mar 14, 2015 19:25:45 GMT -5
3/4 ton 2 wheel drive Chevy's spindles with spindle savers never had one bend, only rip the lower control arm off . and did you think I just made that up? sure its not real or is it hmmmm
|
|
snake
Heat Winner
Posts: 368
|
Post by snake on Feb 10, 2015 23:01:27 GMT -5
mid size cradle is fine it is smaller or less than factory frame to upper ball joint ,do not make arm closer to frame via tire will hit at full turn keep in mind all is based on upper spring mount and upper ball articulation modify upper arm longer with a flat upper ball joint ( slice and reinforce bottom of upper arm ) pic is stock arms use spring mount as kicker to upper spindle
|
|
snake
Heat Winner
Posts: 368
|
Post by snake on Jan 14, 2015 22:09:24 GMT -5
|
|
snake
Heat Winner
Posts: 368
|
Post by snake on Nov 11, 2014 21:14:56 GMT -5
cant find part number for the 10 bia tapered bearings need the race middle axle
|
|
snake
Heat Winner
Posts: 368
|
Post by snake on Nov 1, 2014 22:49:55 GMT -5
whoops maybe a little to high this time
|
|
snake
Heat Winner
Posts: 368
|
Post by snake on Aug 11, 2014 22:52:27 GMT -5
|
|
snake
Heat Winner
Posts: 368
|
Post by snake on Apr 28, 2014 0:16:40 GMT -5
don't assume that that the promoters rules are proper way to do anything , too many versions already ,or they say(may) or must use a venders particular item only
|
|
snake
Heat Winner
Posts: 368
|
Post by snake on Apr 12, 2014 21:33:52 GMT -5
wished other promoters hand same rules for 03 and newer fords just sayin
|
|
snake
Heat Winner
Posts: 368
|
Post by snake on Feb 12, 2014 20:35:13 GMT -5
design flaw back to drawing board a taller spindle or a side mount A arm
|
|
snake
Heat Winner
Posts: 368
|
Post by snake on Nov 11, 2013 1:10:40 GMT -5
nice
|
|
snake
Heat Winner
Posts: 368
|
Post by snake on Sept 23, 2013 21:10:49 GMT -5
|
|