|
Post by hitman99x on Jul 26, 2021 23:03:49 GMT -5
I saw a post about a 20 pin plug and there are 3 pins needed to hotwire the Trans for a 4.3 after a carb convert.
I looked under the truck today to do the hotwire but couldn't find the 20 plug connector, but instead only found a 7 plug connector.
Anyone have an idea if it needs to be hotwired and which wires are needed to do so?
Its a 96 4x4 2 door blazer.
TIA!!
|
|
|
Post by donnym12 on Jul 27, 2021 14:20:17 GMT -5
The 7 pin connector you see is for the neutral safety switch. The connector you need is on the passenger side going straight up and down right above the pan behind the servo.
|
|
|
Post by hitman99x on Aug 2, 2021 18:12:24 GMT -5
The 7 pin connector you see is for the neutral safety switch. The connector you need is on the passenger side going straight up and down right above the pan behind the servo. I found it. Thank you!
|
|