|
Post by beardking on Apr 1, 2020 16:23:43 GMT -5
I have a 95 crown Vic running the stock v8. I was looking for help on how to wire it. The less wires the better lol. And any advice on something for the steering column to mount to would be appreciated thank you.
|
|
demoboy333
Feature Winner
Enter your message here...
Posts: 3,124
|
Post by demoboy333 on Apr 1, 2020 16:29:58 GMT -5
I have a 95 crown Vic running the stock v8. I was looking for help on how to wire it. The less wires the better lol. And any advice on something for the steering column to mount to would be appreciated thank you. If your still running the stock column what we did was took all thread and an plate and pulled it up to the dash bar. Then wiring I don't know much. I had a buddy that ran stock motor and just sat inside the car and traced out the ones he knew he didn't need speakers and all that crap. And then started up the car and would cut and if car dead he wired back together and went that route and turned out a decent set up. This link should have better info on wiring. we-crash.proboards.com/thread/36369/running-stock-4-6-setup
|
|
Landshark007
Feature Winner
I'm not here to win I'm here to make sure you don't win
Posts: 4,228
|
Post by Landshark007 on Apr 1, 2020 17:23:05 GMT -5
I have in the past used U bolt from rear end to hold steering column to Dash Bar. The wires what he said one wire at a time if it dies put it back together
|
|
|
Post by beardking on Apr 1, 2020 17:26:35 GMT -5
Thanks guys appreciate it
|
|
Landshark007
Feature Winner
I'm not here to win I'm here to make sure you don't win
Posts: 4,228
|
Post by Landshark007 on Apr 2, 2020 12:59:49 GMT -5
Don’t forget to bypass fuel shut off
|
|