|
Post by utahtruck87 on Sept 22, 2018 1:53:26 GMT -5
I just bout a Ford F-350 powerstroke for the Utah derby’s and I would like to see how they hold up. So I was kinda hoping someone on here has ran one hand could tell me the weak points and how there’s held up. Thank in advance.
|
|
|
Post by space saver on Sept 23, 2018 1:23:45 GMT -5
are you talkin about the engine itself? or the truck itself?
|
|
|
Post by utahtruck87 on Sept 23, 2018 11:57:39 GMT -5
are you talkin about the engine itself? or the truck itself? No the truck. I have a sbc 383 stroker I will be putting in it.
|
|
|
Post by dean88 on Sept 23, 2018 21:12:01 GMT -5
The 99-04 superduties are extremely tough trucks.
|
|
|
Post by klicky96 on Sept 23, 2018 21:34:59 GMT -5
They're tough but they have there weaknesses. The frame horns will push to nbn one side or the other in front of the k-member. The rails will cave in behind the k-member inward towards the motor. It will push the rails up and kink the frame right in front of the seam support right at the firewall. And the rear rails will blow between the leaf perches. But we have quite a few with over 10 runs each. And we're talking hard hitting runs.
|
|
|
Post by utahtruck87 on Sept 23, 2018 22:12:16 GMT -5
They're tough but they have there weaknesses. The frame horns will push to nbn one side or the other in front of the k-member. The rails will cave in behind the k-member inward towards the motor. It will push the rails up and kink the frame right in front of the seam support right at the firewall. And the rear rails will blow between the leaf perches. But we have quite a few with over 10 runs each. And we're talking hard hitting runs. Do you happen to have picture of what you did to them?
|
|
|
Post by klicky96 on Sept 24, 2018 12:46:02 GMT -5
I don't have pictures but I'll try to write up a page later on and will post it
|
|
|
Post by beefybuilt104 on Sept 24, 2018 20:42:36 GMT -5
I don't have pictures but I'll try to write up a page later on and will post it Dontknowhowtoweld builds a strong superduty but he doesn’t come on here much I don’t think
|
|
|
Post by space saver on Sept 25, 2018 1:58:49 GMT -5
|
|
|
Post by utahtruck87 on Sept 25, 2018 2:01:38 GMT -5
Thanks. I have put all my time into older trucks like the 65 dodge D200. I’m just hoping this will hold up just as good.
|
|
|
Post by space saver on Sept 25, 2018 2:06:03 GMT -5
let me put the link to the ford tricks on here, where dontknowhowtoweld has said some stuff about the 2000's fords.
|
|
|
Post by space saver on Sept 25, 2018 2:06:43 GMT -5
|
|
|
Post by space saver on Sept 25, 2018 2:13:45 GMT -5
also do you have a picture of the d200?
|
|
|
Post by utahtruck87 on Sept 25, 2018 2:17:38 GMT -5
also do you have a picture of the d200?
|
|