|
Post by bepper on Jul 8, 2016 11:31:25 GMT -5
Need wiring harness from older chevy pickup to put in a 51 chevy I will pay for shipping if I need to and give a few bucks for the harness too. Oh ya I need the cable and under hood mainly if you have some of it to the rear that would be great too
|
|
|
Post by bepper on Mar 7, 2018 20:39:17 GMT -5
Gosh, over a year and a half and no one can even comment?
|
|
|
Post by STROMI 121 on Mar 8, 2018 11:40:19 GMT -5
I don't run trucks or I would give you the harness.
|
|
|
Post by klicky96 on Mar 8, 2018 13:21:38 GMT -5
I have personally never seen one ran. I have never watched a derby on YouTube of one being ran either. Your best bet is to get ahold of Painless and see how much they could build one for. Are you trying to go completely stock? Because honestly, you may as well build your own harness. Those trucks have the bare minimum of wiring. Would probably take only 4 hours total to rewire the entire truck.
|
|
|
Post by bepper on Mar 8, 2018 18:58:46 GMT -5
I'm not going to derby it, I'm building a driver, and want to use a early 80s or late 70s harness for the dash and under the hood
|
|
|
Post by beefybuilt104 on Mar 8, 2018 19:20:46 GMT -5
There's no junkyards near you that doesn't have an 80s chevy? Surprising. Probably have better luck with that.
|
|
|
Post by bepper on Mar 8, 2018 19:40:58 GMT -5
Nothing close to me I could probably make one I guess
|
|
|
Post by rennyx on Mar 8, 2018 19:43:23 GMT -5
I have the whole harness from front to back. It is from an 81 chevy. I restored the truck and bought new wiring. I may have cut a couple plugs off it that I needed to reuse. I live in Ontario but, if you really need it we can figure it out. I will check it out tomorrow and see what shape it's in. I haven't looked at it in a couple years.
|
|
|
Post by bepper on Mar 9, 2018 10:00:33 GMT -5
Let me know
|
|
|
Post by klicky96 on Mar 9, 2018 14:11:19 GMT -5
You should have specified with the 80s Chevy truck harness. I read it as you were looking for a harness from a 51ish pickup.
|
|
|
Post by bepper on Mar 9, 2018 17:24:16 GMT -5
Sorry about that
|
|
|
Post by STROMI 121 on Mar 9, 2018 22:21:50 GMT -5
The best way to get an accurate answer is to ask a legitimate question.
|
|
|
Post by rennyx on Mar 10, 2018 16:26:09 GMT -5
I can't get to harness at the moment. Too much snow and ice to chip through where it is stored.
|
|
|
Post by bepper on Mar 10, 2018 20:51:17 GMT -5
I can't get to harness at the moment. Too much snow and ice to chip through where it is stored. Not a problem, I can wait. Just let me know when you get to it and what you want for it. Ok
|
|