|
Post by tiger13e on Feb 26, 2014 16:37:46 GMT -5
Only reason i used pieces instead of solid plate was for money and for ease and time. Sure you can set the plate that goes between block and engine down on a sheet of steel and cut it out or even a c4 bell housing. But by the time you ground and cut to the contours of the bell housing i would have had mine done. If you look at the back side of a bell housing where i bolted my plate on its not flat. There are dipped areas for every bolt and rounded edges everywhere. That is why mine was pieced together. Once the front is done and they are tied together its not going to bend.
|
|