|
Post by jugulator on Sept 19, 2011 9:41:29 GMT -5
I'll never run a tempo again,,, and I can make them run forever,,, BUT,,,,,weak tie rods and CV joints,,,, ya,, I strengthen them,, and they still broke... ................lenny
|
|
|
Post by 05to18 on Jan 11, 2012 20:55:47 GMT -5
any1 know to do a push buttom on it
|
|
|
Post by derbyb70 on May 21, 2012 22:10:39 GMT -5
Is there a way to bypass the fuel safety switch??
|
|
|
Post by C4 on May 21, 2012 23:37:20 GMT -5
^^^^^By running the fuel pump directly to the battery, outside of the factory harness, that problem is automatically solved.
|
|
T-Brell
Feature Winner
Posts: 2,295
|
Post by T-Brell on May 22, 2012 19:57:13 GMT -5
easier than that, it's just a normally open switch. cut both wires of the switch, strip them, twist them(or wire nut), and put tape around it and that's all ya have to do.
|
|
|
Post by derbyb70 on May 29, 2012 16:56:35 GMT -5
Anyone got any pics of a built one?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 29, 2012 19:01:38 GMT -5
|
|
|
Post by ld50 on May 29, 2012 19:34:03 GMT -5
The rearend of the first tempo I ran The second i built right before its second heat. Right after its second and final heat. The third tempo I built fresh. After 3 figure 8 heats and a feature
|
|
|
Post by derbyb70 on May 29, 2012 21:53:22 GMT -5
Thanks, i have my car with the ass end down(mini vic) not sure how its going to bend.
|
|
|
Post by hurley39x on Jul 9, 2012 9:25:10 GMT -5
you guys are saying move the starter solenoid how are you guys doing that
|
|
|
Post by C4 on Jul 9, 2012 10:05:44 GMT -5
^^^Most people dont understand the difference between a solenoid and a relay. It is the starter relay that you will be moving. A starter solenoid is attatched to the starter, and is not practically movable.
|
|
|
Post by hurley39x on Jul 9, 2012 11:24:24 GMT -5
alright so hows it done?
|
|
|
Post by C4 on Jul 9, 2012 12:49:18 GMT -5
Relay...unbolt, move, rebolt. Clean off the new mating surface...it will serve as the relay's ground.
Solenoid...it's not done.
|
|
|
Post by hurley39x on Jul 9, 2012 13:24:00 GMT -5
dj mine does the same thing so dont feel bad it hasnt hurt anythiung as of yet
|
|
|
Post by hurley39x on Jul 9, 2012 15:15:56 GMT -5
have 2 questions how are people going about the cv axles since ive been hearing there weak and what are people running pretaining to the rear. are you guys running the stock bars or replacing them. my local promotor said if i wanted to i can replace them with steel tubing and wasnt for sure if it was worth it or not
|
|