17
Heat Winner
Posts: 317
|
Post by 17 on Mar 5, 2022 10:43:56 GMT -5
Thanks, I did not see it when I looked for it, I will look again.
|
|
|
Post by Luke Wells on Mar 6, 2022 16:28:57 GMT -5
Thanks, I did not see it when I looked for it, I will look again. Here ya go. we-crash.proboards.com/thread/27327I've seen a couple run. Honestly they weren't great. The front frame horns dip down and out kinda like a 70s ford but worse. They tend to spaghetti out right there pretty ugly.
|
|
|
Post by roughneck06 on Jul 14, 2022 8:22:38 GMT -5
Is there any gm spindles and/or a arms that give extra height that bolt direct. Rules state suspension swap have to be make to make so ford spindles/arms are out
|
|
|
Post by cheezwhiz31 on Jul 18, 2022 8:12:10 GMT -5
Is there any gm spindles and/or a arms that give extra height that bolt direct. Rules state suspension swap have to be make to make so ford spindles/arms are out Not that i'm aware of. Just get some 80s gm arms and put washers under the lower of the 2 upper bolt that hold arm down so i can pivot farther down the outside pocket. I heat up and beat the pocket in some too to give it a little more room to travel. About all ya going to get.
|
|
|
Post by smashford on Aug 1, 2022 0:26:36 GMT -5
You could try Astros flipped? I haven't jet a possibly
|
|
|
Post by STROMI 121 on Aug 1, 2022 21:32:27 GMT -5
The real question is does the promoter actually know what a legal caddy looks like? This has lent so much to the imaginative shit that I have seen pass as legal.
|
|
|
Post by roughneck06 on Mar 5, 2023 22:45:02 GMT -5
With hump plates on a 73. Would you do the caddy half trunk or dish trunk 12"(all I'm allowed) and just dimple twice
|
|
|
Post by STROMI 121 on Mar 6, 2023 20:53:48 GMT -5
Are you running the stock bumper?
|
|
|
Post by roughneck06 on Mar 7, 2023 1:00:14 GMT -5
Have a 75 bumper and brackets on rear now welded 4"
|
|
|
Post by DerbyKing88s on Mar 7, 2023 23:17:12 GMT -5
Dish. Half trunk is gross.
|
|