GET#911jrBENT
Future Icon
A built car is only as good as its driver!
Posts: 95
|
Post by GET#911jrBENT on Feb 12, 2018 22:39:04 GMT -5
How are you guys setting a sbc engine in these without getting to weld happy?
|
|
mn13
Heat Winner
Posts: 231
|
Post by mn13 on Feb 13, 2018 13:51:03 GMT -5
set a 4" c channel across the stock motor mounts, weld in, put a piece of flat iron in at an angle and weld the mounts to the angle iron. I had to cut the center section of the c channel to clear my oil pan. If I can get the pics off my phone I could post them how I did it
|
|
mn13
Heat Winner
Posts: 231
|
Post by mn13 on Feb 13, 2018 13:55:36 GMT -5
|
|
mn13
Heat Winner
Posts: 231
|
Post by mn13 on Feb 13, 2018 13:56:39 GMT -5
here is part of it, add the angle gussets on top weld mounts to it and drop it on
|
|
|
Post by clueless on Feb 16, 2018 18:12:14 GMT -5
Just build 2 right triangles out of 2x4 square tubing and weld them to the inside of the frame rails. |\ /| worked alright for me. My rules won't allow engine cradle to tie frame rails together if it's not stock. I have pics if you need some.
|
|